Many owners will find toilets have a variety of problems after using the toilet for a period of time. For example, the toilet tank is filled with water slowly, cracks appear at the foot of the base, the toilet is not installed after the wall is installed, and the toilet is cleaned. Rust yellow, cracked toilet and so on. However, in fact, this kind of problem is often not the fault of the quality of toilets. It is a mistake of various misuses or objective circumstances. Today Xiao Bian has come to analyze with you.
First, the toilet crack
First of all, let's take a look at the toilet crack mentioned above. Toilet bowl or chassis cracking, or the entire block falling off, may be related to environmental factors. For example, if the temperature in winter is too cold and the indoor temperature is below 0 degrees, the water stored in the toilet tank will freeze, and the volume of the ice cube may expand to the breakwater tank. If the owner does not use the toilet for a long time, the water flow in the water tank will not flow for a long time, and freezing will easily cause cracking of the water tank.
Anti-freeze trick: In winter, to prevent damage to the toilet due to ice formation, please leave the remaining water when not in use.
The methods and steps for depletion are as follows: 1. Close the water inlet valve; 2. Remove the drainage screw after unscrewing; 3. Tighten the drainage bolt after the remaining water is drained, otherwise it will cause water leakage. There will be stagnant water at the toilet's anti-water bend, and it can be sucked out with a sponge cloth or a water pump to prevent the toilet from freezing for a long time. In addition to drainage, pouring antifreeze in the water tank, or in the water with alcohol and salt, can reduce the freezing point of water, and can also effectively prevent freezing.
Second, slow water injection into the toilet tank
If there is a slow water injection in the toilet tank, first check the water pressure, the water pressure is too small, it is a water supply problem, and has nothing to do with the quality of the toilet. If the water pressure is normal, please check the water inlet valve in the water tank component for obstructions. If any, remove the impurities.
Third, cracks in the foot of the toilet base
After the toilet has been installed for a period of time, cracks appear on the feet of the base and will expand. This is due to the fact that the cavity of the base is filled with cement and is not related to the quality of the toilet. The cement will expand due to water swelling to crack the toilet. The correct installation method is to use a flange for the one-piece toilet seat, separate it with a floor anchor screw, or fix the toilet chassis with silicone.
Fourth, after the toilet is installed not rely on the wall
After the toilet is installed, it does not depend on the wall. This is related to the choice of the toilet drainage distance and the distance between the reserved sewage outlet pipe and the wall, and has nothing to do with the quality of the toilet. There are three sizes of 210mm, 305mm, and 400mm. Under normal circumstances, the installation dimensions are 190-210mm, 285-305mm, and 380-400mm, which means that the back of the toilet is 20mm from the wall gap.
When purchasing, the user should select the size of the toilet according to the actual distance from the wall to the reserved sewage pipe in the home. If the distance between the drain pipe and the wall has been fixed and is not standardized, an optional shifter can be used to adjust if there is no suitable drain to choose from. The shifter can generally increase or decrease the center maximum distance by about 100mm.
Fifth, wash the toilet surface partially rust yellow
The use of toilets for a long time is prone to yellowish rust on the cleansing surfaces of toilets. The rust of the toilet flushing surface is yellowish, which has great influence on the appearance and is uncomfortable to use. It is also washed and tired. When this happens, the owner usually thinks there is a problem with the toilet. It is actually a water quality problem and it has nothing to do with the quality of the toilet. Due to water quality, the toilet will have yellow dirt on the surface after prolonged use. At this point, scrub with a detergent and then rinse with clean water.
<\p><\div>
Skin Scrubber,Ultrasound Skin Scrubber,Skin Care Machine,Stainless Steel Scrubber
Shenzhen Hongyutai Technology Co., Ltd. , https://www.redyut.com